Can i swap shafts between a taylormade r580 and a taylormade tour burner?

I have the stock taylormade shaft in the r580xd and an aldila nv in the burner. I want to get a new shaft for the burner and replace the stock shaft in the 580xd with the shaft from the burner. Will this be an easy swap or not?|||It depends on the tip diameters of the shafts .335/.350... it's easy enough if they're compatible and cheap too.



Re-shafting fee $20.00-$25.00 Labor only No part. Keep same grip.

http://www.golfsmith.com/display/?page=c鈥?/a>



Cost of new shaft for burner (anywhere from 19.00-300.00 your choice) and grip.

and cost of re shafting Labor. $20.00-$25.00 re-shaft $4.00 re-grip.|||I'm pretty sure they're both .350 hosel diameters, so you should be fairly OK. You may need a shim if the NV is .335 tip, but those are pretty cheap. You're probably going to need an extension in the butt of the driver, unless you want it to be ~43"- again, reasonably priced (Don't make the extension longer than 2", though, because it'll be easier to break). That also means a new grip, to boot, unless you can save it- not an easy task.|||you can put any shaft in any driver as long as the tip diameter is the same